RDBM Power Wall Project Log Testing

Image
Rapid Deployment Battery Module (RDBM)      Today's update is The Testing of the Dimensions at Cellular Level Before proceeding into the bigger Design Which is 5P and The Much Bigger One the 25P and Then to The Bigger Bigger One Which is The 100P. I Tried to Make the Project Easier at my Side by Scouting the Internet of Things for Designs that are Readily Available that Would Fit my Project, so as to Lessen the Work and Expenses on Materials and Energy. Because This Project is Going to Consume so much Filaments and Electric Power if Started From Scratch. Taking Into Consideration my Source of Income and Free Time to Work on This Project is the First Barrier to Make This Thing Work. But, so far I wasn't Able to Find A Design out There that Could be use for my Intended Purpose, not to Mention Most Available 3D Files in the Internet are STLs that are difficult to edit and most cannot be undone.      I Ended up Designing my Own Holder From Scratch. I Start

Greasy Mushy Heavy

Early this morning I went to the garage to fix the Raiders flat rear tire. It was already three days ago since a nail punctured it after a drinking spree on the way home.

I removed the rear wheel the other day so as I can take it as easy and early as possible to the vulcanizing shop. The shop was a bit busy when I arrived their, but since the mechanic was fast and good with his profession I had my wheel fixed early this morning and went home immediately to install the wheel.

The installation was as easy as uninstalling even with the disk breaks. The mechanical setup of the wheel was not as complicated as I thought.

The Raider was up and running again after a few minutes and I went for 15 minutes for a test drive and opened up Crywolf after the run.

Comments

Popular posts from this blog

Political Slip of a Tongue - Pia Cayetano

Bedini - Imhotep Fan Oscillator

The Priceless Dog