RDBM Power Wall Project Log Testing

Image
Rapid Deployment Battery Module (RDBM)      Today's update is The Testing of the Dimensions at Cellular Level Before proceeding into the bigger Design Which is 5P and The Much Bigger One the 25P and Then to The Bigger Bigger One Which is The 100P. I Tried to Make the Project Easier at my Side by Scouting the Internet of Things for Designs that are Readily Available that Would Fit my Project, so as to Lessen the Work and Expenses on Materials and Energy. Because This Project is Going to Consume so much Filaments and Electric Power if Started From Scratch. Taking Into Consideration my Source of Income and Free Time to Work on This Project is the First Barrier to Make This Thing Work. But, so far I wasn't Able to Find A Design out There that Could be use for my Intended Purpose, not to Mention Most Available 3D Files in the Internet are STLs that are difficult to edit and most cannot be undone.      I Ended up Designing my Own Holder ...

Oopps I done it Again

I went to the quarry the other day where our dirt jump ramps are still and waiting for me. I checked the surroundings first to see if everything where in the same condition as we left it.

I rolled back and fourth the ramp jumping over it without the bike just to overcome the nervous and get use with it. And finally after a few minutes I decided to take a jump, I took my bike and positioned at the starting line and pedaled through the ramp and to bad I did it again. I went down crashed landed my speed was too slow that I did not reach the receiver and tumble over and got a new wounds on my nose and shin! Still not contented, I tried it again adding more speed and poof I did it, I cleared the ramp although it was a rough landing but at least I didn't crash!

Comments

Popular posts from this blog

Zohan

I am a Man from Renaissance Period

First Photos Part 1